top of page
IFT-120_Controlab_edited.png

IFT - GROUND

FAULT MONITORS

In most industrial environments, ground faults can cause significant damage. Since ground faults are unavoidable in almost all industrial environments, our ground fault monitors enable you to find the source of the leak quickly and easily, before a major problem occurs and damages your equipment. The IFT-120 is designed to help you locate ground faults quickly.

 

As soon as a ground fault occurs on any of your electrical equipment, our IFT monitor will automatically switch on its alarm light and engage its relay. The monitor's normally open or normally closed contact can be used to signal the fault to your PLC, or to take any other appropriate action (stop the motor concerned, or activate an audible or visual alarm). The monitor will remain in alarm until the reset function is activated. In the event of a total loss of power to the monitor terminals, this will act as a reset. The alarm will remain active as long as voltage is present. Even if the fault disappears, the monitor will retain the alarm function until a complete reset. This function enables you to quickly and accurately identify the source of your leak.

Power supply: 120 VAC or 24 VAC-VDC

Operating voltages: 120 to 600 volts

Operating frequencies: 50/60/400 Hz

Consumption current: 3 mA at rest - 15 mA in alarm

Adjustable response time

Adjustable detection current

N/O or N/C contacts

Cast in epoxy

Request our product sheet

Other downloads

Installation video

Coming soon

Coming soon

bottom of page