IFT-120

Once a ground fault occurs on your electrical equipment, our IFT-120 and IFT-24 monitors automatically turn on the alarm LED and will initiate its relay. The normally open or normally closed contact of our monitor can be used to report the fault to your PLC or to take any other appropriate action (stop the motor concerned or activate an audible or visual alarm). The monitor will remain in alarm mode until the reset function (reset) is activated. If there is a total loss of power to the terminals of the monitor, this will act as a reset. The alarm will remain activated as long as the voltage is present. Even if the fault disappears, the monitor will remain in alarm mode until completely reset. This function allows you to quickly and accurately identify where your fault is located.

▶ High-quality design
▶ Two (2) year warranty
▶ IFT-120 – CSA and UL approved
▶ IFT-24 – CSA approved
▶ Fully cast in epoxy
▶ 2 inches CT included

Supply voltage: 120 VAC
Operating Voltage: 120 à 600 volts
Operating frequencies : 50/60/400 Hz
Current consumption
Resting current consumption: 3 mA.
Alarm current consumption: 15 mA.
Response time
4 preadjusted: 30 msec., 100 msec., 1.00 sec. and 3.00 sec.
Current detection
4 preadjusted: 100 mA, 300 mA, 1.00 A and 3.00 A
Output contact: Relay
Contact rating: 30 VDC / 250 VAC – 3.5 A
Contact types: 1 open (N/O) and 1 closed (N/C)
Option RL-Kit: NEMA-4X Remote Light
On request: Custom CT
Also available with 24 VAC-VDC supply (IFT-24)